Generac Generator Manual de usuario

POWER SYSTEMS, INC.®DANGERONLY QUALIFIED ELECTRICIANS OR CONTRACTORS SHOULD ATTEMPT INSTALLATION!PowerMaster Technical ManualThis manual should remai

8 8 Section 4 — Electrical DataElectrical Schematic - Drawing No. 0F8146-A

9Section 4 — Electrical DataElectrical Schematic - Drawing No. 0F8146-A 9

10 Section 5 — Exloded Views & Parts ListsAssembly - Drawing No. 0F9110-A

11ITEM PART NO. QTY. DESCRIPTION 1 0F9080 1 LOAD DISCONNECT ENCLOSURE 2 0F9081 1 LOAD DISCONNECT ENCLOSURE COVER 3 0C3211T 2 RELAY 40A

12 Section 6 — Notes

13Section 6 — Notes

Part No. 0G0734 Revision 0 (04/07/06) Printed in U.S.A.Section 7 — WarrantyPowerMaster Technical ManualGENERAC POWER SYSTEMS STANDARD TWO-YEAR LIMITED

INTRODUCTIONThank you for purchasing the PowerMaster Assembly by Generac Power Systems, Inc.Every effort was expended to make sure that the informat

Table of ContentsPowerMaster Technical Manual 1Introduction ...Inside Front Cover Read This Manual Thoroughly ...

2 Study these SAFETY RULES carefully before install-ing, operating or servicing this equipment. Become familiar with this Owner’s Manual and with the

3 ELECTRICAL HAZARDS All generators covered by this manual produce dangerous electrical voltages and can cause fatal electrical shock. Utility pow

4 1.1 INTRODUCTIONThis manual has been prepared especially for the purpose of familiarizing personnel with the design, application, installation, and

2.3 CONNECTING THE SOURCE VOLTAGE(S) AND LOAD(S)The source voltage(s) are taken from the load center and connected to the PowerMaster assembly as fol

6 Section 2 — InstallationPowerMaster Technical Manual2.5 INSTALLING THE AUXILIARY SWITCHES TO THE TRANSFER SWITCHThe included auxiliary switches ne

73.1 TESTING THE POWERMASTER OPERATIONThe PowerMaster assembly can be functionally tested using the following steps:Note: the following steps will